Thompson Center Encore Classifieds
Find your Encore Barrels here!

Home » General Conversation » DIY Gunsmithing » Refinished Stock/Forearm
Re: Refinished Stock/Forearm [message #1188 is a reply to message #998] Sun, 28 February 2010 10:16 Go to previous message
jdunlap is currently offline  jdunlap
Messages: 3
Registered: February 2010
Location: Wiggins, MS
Forum Newbie
Very nice, I like the look of that. I'm hoping to refinish mine this spring, I'm wanting to do a hand rubbed oil finish on it with a new recoil pad as well. We'll see how it turns out...
Anyway, very nice job on the stock! Cool

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Previous Topic: Front sight screw size...??
Next Topic: forearm screws
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ]

Current Time: Fri May 31 21:45:15 EDT 2024
.:: Contact :: Home ::.