Thompson Center Encore Classifieds
Find your Encore Barrels here!

Home » General Conversation » DIY Gunsmithing » Misfires with the Prohunter...solutions??
Re: Misfires with the Prohunter...solutions?? [message #15217 is a reply to message #15206] Fri, 19 October 2012 20:06 Go to previous messageGo to next message
bigbuck28 is currently offline  bigbuck28
Messages: 24
Registered: May 2011
Location: MA
Forum Newbie
learned something new today thanks to doyle.


Ill keep everyone updated on my progress...spring shoud be here next week

Report message to a moderator

Re: Misfires with the Prohunter...solutions?? [message #15333 is a reply to message #15217] Wed, 24 October 2012 10:14 Go to previous messageGo to next message
bigbuck28 is currently offline  bigbuck28
Messages: 24
Registered: May 2011
Location: MA
Forum Newbie
Just replaced the Hammer spring and the firing pin return spring...all with no problems...
After fired the hammer returns back to where it should off the firing pin.
The hammer spring was the same size as my original.
Just placed a spent cartridge in the gun and the primer strike is notably different.....much deeper

I think were in business!!

Thanks to you guys on this site...I really couldn't have done it with out you.....Now on to my other encores to replace them..

Report message to a moderator

Re: Misfires with the Prohunter...solutions?? [message #15338 is a reply to message #15333] Wed, 24 October 2012 12:50 Go to previous messageGo to next message
Doyle is currently offline  Doyle
Messages: 318
Registered: June 2011
Location: Starkville, Ms
Forum Regular
Did it adversely affect your trigger pull?

Report message to a moderator

Re: Misfires with the Prohunter...solutions?? [message #15344 is a reply to message #15338] Wed, 24 October 2012 19:57 Go to previous message
bigbuck28 is currently offline  bigbuck28
Messages: 24
Registered: May 2011
Location: MA
Forum Newbie
I don't think it changed my trigger pull at all to be honest with yah... Trigger still feels the same to me.

The springs were the same size..

[Updated on: Wed, 24 October 2012 19:58]

Report message to a moderator

Previous Topic: Encore Forend
Next Topic: Forearm screw size
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ]

Current Time: Mon May 13 02:41:22 EDT 2024
.:: Contact :: Home ::.