Thompson Center Encore Classifieds
Find your Encore Barrels here!

Home » General Conversation » Gun Talk » New pistol "scabbard" - NcStar CVRSCB2919B
New pistol "scabbard" - NcStar CVRSCB2919B [message #26519] Fri, 13 December 2013 22:11 Go to next message
cajuntec is currently offline  cajuntec
Messages: 1250
Registered: November 2009
Location: Williamsburg, VA
Top Contributor
Forum Admin
I just bought a "NcStar CVRSCB2919B Tactical Rifle Scabbard Padded Airsoft Gun Case Black". They are in lots of places around the internet, and I've been putting off buying one for a while now. But I had seen others recommend them, and I finally broke down and bought one. Cost me $26.95, and it's really a nice carrying piece for the money. Couple of pics:

http://img.photobucket.com/albums/v111/cajuntec/photo2-2_zps7d7c8a72.jpg

http://img.photobucket.com/albums/v111/cajuntec/photo1-2_zpse3dff501.jpg

That's a 15" 7mm-08 barrel on that Encore pistol with a Burris scope. Fits really nice. The two straps really keep it secure in there, and it carries over my shoulder really easy, freeing up my hands. I think I have a real winner in this one.

All the best,
Glenn

If at first you don't succeed... buy newer / better equipment!

Report message to a moderator

Re: New pistol "scabbard" - NcStar CVRSCB2919B [message #26527 is a reply to message #26519] Sat, 14 December 2013 09:45 Go to previous messageGo to next message
lepcur is currently offline  lepcur
Messages: 1270
Registered: April 2011
Location: Westpoint,Ca.
Top Contributor
It looks like it should work well Glenn and it has a place for extras. I wonder if it will fit with a shorty bi-pod attached? Mike

Report message to a moderator

Re: New pistol "scabbard" - NcStar CVRSCB2919B [message #26533 is a reply to message #26527] Sat, 14 December 2013 12:12 Go to previous messageGo to next message
cajuntec is currently offline  cajuntec
Messages: 1250
Registered: November 2009
Location: Williamsburg, VA
Top Contributor
Forum Admin
Mike,
I can test that. Give me a few minutes and I'll see how it fits. I'll post pics as well. I have a Harris HBRM (6-9" legs).
All the best,
Glenn

If at first you don't succeed... buy newer / better equipment!

[Updated on: Sat, 14 December 2013 12:23]

Report message to a moderator

Re: New pistol "scabbard" - NcStar CVRSCB2919B [message #26534 is a reply to message #26533] Sat, 14 December 2013 12:36 Go to previous messageGo to next message
cajuntec is currently offline  cajuntec
Messages: 1250
Registered: November 2009
Location: Williamsburg, VA
Top Contributor
Forum Admin
Fits good, but the rubber feet on the Harris kind of "stick" to the inside. Not bad, but just a little bit.

The pistol with the bi-pod:

http://img.photobucket.com/albums/v111/cajuntec/IMG_0093_zps9a606cae.jpg

Stuffed into the scabbard with bi-pod attached:

http://img.photobucket.com/albums/v111/cajuntec/IMG_0094_zpsba90bcd2.jpg

All closed up and secure with bi-pod attached:

http://img.photobucket.com/albums/v111/cajuntec/IMG_0095_zps0b38d7aa.jpg

Closed side view with the pistol inside (bi-pod still attached):

http://img.photobucket.com/albums/v111/cajuntec/IMG_0096_zps8bbf8109.jpg

All the best,
Glenn

If at first you don't succeed... buy newer / better equipment!

Report message to a moderator

Re: New pistol "scabbard" - NcStar CVRSCB2919B [message #26574 is a reply to message #26534] Mon, 16 December 2013 09:10 Go to previous messageGo to next message
lepcur is currently offline  lepcur
Messages: 1270
Registered: April 2011
Location: Westpoint,Ca.
Top Contributor
Thanks Glenn, I'll have to check into 1 of these. Mike

Report message to a moderator

Re: New pistol "scabbard" - NcStar CVRSCB2919B [message #26585 is a reply to message #26519] Mon, 16 December 2013 19:26 Go to previous messageGo to next message
wwkmag is currently offline  wwkmag
Messages: 588
Registered: January 2013
Location: Maine
Senior Member
Does this have a zipper closeure around one side of it? I think I see one in the pic , but not sure. Thank you, Mike...WWK

Report message to a moderator

Re: New pistol "scabbard" - NcStar CVRSCB2919B [message #26591 is a reply to message #26585] Mon, 16 December 2013 21:50 Go to previous messageGo to next message
cajuntec is currently offline  cajuntec
Messages: 1250
Registered: November 2009
Location: Williamsburg, VA
Top Contributor
Forum Admin
There is a zipper closure down around where the grip would be. You can see it in that second picture above, right under the grip. I don't think I'll ever use it. I'd rather use the snap closure and buckle that I show closed in the third and fourth picture instead of trying to leverage it out the bottom via the grip area. It's an "expandable" scabbard - the folded over part that has the buckle holding it down around the muzzle area can be unsnapped and the buckle adjusted to accommodate longer barrels. But "as is" when it showed up - fit the Encore with a 15" barrel perfectly for me. It's surely no "custom", but for $27, I thought it was a heck of a deal.
All the best,
Glenn

If at first you don't succeed... buy newer / better equipment!

Report message to a moderator

Re: New pistol "scabbard" - NcStar CVRSCB2919B [message #26604 is a reply to message #26591] Tue, 17 December 2013 09:03 Go to previous messageGo to next message
wwkmag is currently offline  wwkmag
Messages: 588
Registered: January 2013
Location: Maine
Senior Member
Thanks for the info, it sounds like i should have one....
Mike..WWK

Report message to a moderator

Re: New pistol "scabbard" - NcStar CVRSCB2919B [message #26630 is a reply to message #26604] Tue, 17 December 2013 19:27 Go to previous messageGo to next message
ashdigger is currently offline  ashdigger
Messages: 36
Registered: November 2013
Location: United States
Novice Contributor
Thanks for the post I'll find one, that's just what I've been looking for..

Report message to a moderator

Re: New pistol "scabbard" - NcStar CVRSCB2919B [message #26634 is a reply to message #26630] Tue, 17 December 2013 20:17 Go to previous messageGo to next message
lepcur is currently offline  lepcur
Messages: 1270
Registered: April 2011
Location: Westpoint,Ca.
Top Contributor
I noticed they come in digital camo, tan and o.d. green as well as the black, looks like a pretty good deal to me. Mike

Report message to a moderator

Re: New pistol "scabbard" - NcStar CVRSCB2919B [message #26943 is a reply to message #26634] Sat, 28 December 2013 21:05 Go to previous message
ashdigger is currently offline  ashdigger
Messages: 36
Registered: November 2013
Location: United States
Novice Contributor
I just received my new case, I ordered it in tan, great quality for the money and its great for a 15" with a scope, Thanks for the tip cajuntec.......

Report message to a moderator

Previous Topic: Rechamber barrel
Next Topic: Encore Black Powder question???
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ]

Current Time: Thu May 02 23:58:05 EDT 2024
.:: Contact :: Home ::.