Thompson Center Encore Classifieds
Find your Encore Barrels here!

Home » General Conversation » DIY Gunsmithing » Open sights
Open sights [message #27779] Wed, 22 January 2014 20:27 Go to next message
wwkmag is currently offline  wwkmag
Messages: 588
Registered: January 2013
Location: Maine
Senior Member
Are contender and encore pistol front and rear sights the same hole spacing and curverture?

Report message to a moderator

Re: Open sights [message #27780 is a reply to message #27779] Wed, 22 January 2014 20:30 Go to previous messageGo to next message
jamesgammel is currently offline  jamesgammel
Messages: 1708
Registered: August 2012
Location: Lovell, Wyoming
Top Contributor
definately not the rear sites (for curvature). If they were, one model scope base would fit both.
Jim

[Updated on: Wed, 22 January 2014 20:34]

Report message to a moderator

Re: Open sights [message #27781 is a reply to message #27780] Wed, 22 January 2014 20:35 Go to previous message
wwkmag is currently offline  wwkmag
Messages: 588
Registered: January 2013
Location: Maine
Senior Member
Thank you!

Report message to a moderator

Previous Topic: Contender forearm question...
Next Topic: 20 ga slug barrel
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ]

Current Time: Fri May 17 03:50:32 EDT 2024
.:: Contact :: Home ::.