WTB 14" Barrels [message #29272] |
Sat, 01 March 2014 17:51 |
jamesgammel
Messages: 1708 Registered: August 2012 Location: Lovell, Wyoming
|
Top Contributor |
|
|
The easiest to describe:
1) 218 Bee
2) 357 Mag, 256 Win, 222Rem, 223 Rem, and 7T/CU WITH originally shipped Sights. ALL will have front sights which are 2 7/8" long. Pix can be found in my "WTB" under the contender parts for sale section. Rears will be what most refer to as "sillouette" "saddle" or "micrometer" style sights.
3) 30Herrett, 30-30, 357 Herrett, 35 Remington, 41 Mag, and 44 Mag.
These should have either Williams or T/C copy front and rear sites. The T/C copies will be the same as those used on #2, above, the rear Williams will be so marked, and have white reference lines for adjustment purposes. If any doubt, just PM or email me a pix.
If the front site has been removed, the barrel will have either a 1 5/8 or 2 inch hole spacing center-to-center. Other than the 218 Bee, I don't want any with 1 1/2" front site hole spacing (first hole will be about 5/16s from barrel crown on the non-wants as well, wants are much further back for that first hole)
Again, TIA,
Jim
[Updated on: Fri, 07 March 2014 00:08] by Moderator Report message to a moderator
|
|
|
Re: WTB 14" Barrels [message #29275 is a reply to message #29272] |
Sat, 01 March 2014 19:21 |
dtalbot
Messages: 194 Registered: April 2011 Location: Ozarks, MO
|
Junior Member |
|
|
These barrels listed in #2 above, at least the .357 MAG and the .256 Win MAG, are not factory standard barrels in the configuration you are requesting. Instead, these 2 barrels were limited productions affixed to the flatside IHMSA frames, and so marked by serial numbers predicated by IHMSA ####. I have the flatside and associated .357 BBL complete. I also have the rest of the barrels you are looking for.
PM inbound.
[Updated on: Sat, 01 March 2014 19:23] Report message to a moderator
|
|
|
|
|
|
|
|
|
|
|