contender barrel [message #38777] |
Wed, 15 July 2015 00:24 |
bbraquet
Messages: 131 Registered: March 2012 Location: tx
|
Junior Member |
|
|
I need to know if a armor alloy barrel will work on a blue frame.Thanks Bob
|
|
|
|
|
|
Re: contender barrel [message #38786 is a reply to message #38782] |
Wed, 15 July 2015 09:38 |
jamesgammel
Messages: 1708 Registered: August 2012 Location: Lovell, Wyoming
|
Top Contributor |
|
|
I suspect he's getting it online and may not be able to do that himself. Some are willing and capable of checking for you if they have a frame to try the barrel and pin on. Otherwise, ask for a good pix of the hinge pin hole and check for frosted vs. shiny. Even if he doesn't have a pin/frame he can use the shank of a typical 3/8's drill bit; if it'll go thru easily it's been reamed and will fit your frame (JUST the non-cutting shank). I bought an unreamed AA frame,picked it up Monday with another frame and two full guns, so I need unreamed barrels, just one 10 and one 14n so I can complete a full pistol as a representative in my "collection". There's plenty of reamed ones out there, just make sure the one you get is one of them.
Jim
[Updated on: Wed, 15 July 2015 09:39] Report message to a moderator
|
|
|
|
|
|
Re: contender barrel [message #38793 is a reply to message #38791] |
Wed, 15 July 2015 13:19 |
jamesgammel
Messages: 1708 Registered: August 2012 Location: Lovell, Wyoming
|
Top Contributor |
|
|
I can. AA's pins are usually SS but .002 smaller in diameter. And yes, you got the serious play correct as well. You may exibit headspacing issues. With two thousand's slop for it to flop around.
Jim
[Updated on: Wed, 15 July 2015 16:47] by Moderator Report message to a moderator
|
|
|