Thompson Center Encore Classifieds
Find your Encore Barrels here!

Home » General Conversation » DIY Gunsmithing » Cut and Recrown a Barrel
Cut and Recrown a Barrel [message #39551] Fri, 13 November 2015 17:19 Go to next message
winman1550 is currently offline  winman1550
Messages: 35
Registered: December 2014
Location: Michigan
Novice Contributor
Wondering who would you recommend on cutting and recrowning a barrel for and Encore in regards to Quality, Cost, And Turn around time.

All suggestions are greatly appreciated.

Thanks, Greg

Report message to a moderator

Re: Cut and Recrown a Barrel [message #39570 is a reply to message #39551] Tue, 17 November 2015 08:57 Go to previous message
gemihur is currently offline  gemihur
Messages: 312
Registered: March 2012
Location: Ridgelines of Virginia
Forum Regular
David White would be my recommendation.
http://www.dandtcustomgunworks.websitetoolbox.com/post/tc-co ntenders-encores-7271180?pid=1285971895

Think twice...shoot once.

Report message to a moderator

Previous Topic: 300blk encore build
Next Topic: Determining what sights to fit
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ]

Current Time: Fri May 03 05:01:51 EDT 2024
.:: Contact :: Home ::.