Thompson Center Encore Classifieds: DIY Gunsmithing

Home » General Conversation » DIY Gunsmithing » How hard is it

Show: Today's Messages :: Polls :: Message Navigator
E-mail to friend

How hard is it [message #5207]

Mon, 06 June 2011 06:42

Doubletap
Messages: 13
Registered: May 2011

Forum Newbie

To put a spring kit in an encore, any diagrams availble

Report message to a moderator

Re: How hard is it [message #5209 is a reply to message #5207]

Mon, 06 June 2011 08:04

Crubear
Messages: 1798
Registered: March 2010
Location: NW Georgia

Top Contributor
Forum Moderator

Go here and download the PDF, should have what you need to replace the springs

http://www.bellmtcs.com/store/index.php?cid=456&

Honestly, I have all the barrels I want or could ever need..... wait, look, there's another!!

[Updated on: Mon, 06 June 2011 08:05]

Report message to a moderator

Re: How hard is it [message #5265 is a reply to message #5207]

Mon, 13 June 2011 21:20

granjack
Messages: 33
Registered: April 2011

Novice Contributor

Using the diagram Crubear mentioned it only took me about an hour to do my G2 the first time!!! Both the G2 and Encore are pretty much the same. Now I can do it in about 2-3 minutes. Once you get it right the first time, it's a snap from then on.

A veteran is someone who wrote a check to Uncle Sam payable for "up to and including my life".

Report message to a moderator

Previous Topic:	Screw sets
Next Topic:	Encore trigger pull

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

]

Current Time: Mon May 13 02:11:24 EDT 2024