Thompson Center Encore Classifieds
Find your Encore Barrels here!

Home » General Conversation » DIY Gunsmithing » Bullet casting (Anyone casting out there?)
Bullet casting [message #3520] Fri, 18 February 2011 07:13 Go to next message
xray66 is currently offline  xray66
Messages: 14
Registered: December 2010
Location: Seattle
Forum Newbie
Would enjoy hearing from experienced 'caster as to best buys in equipment would be before I begin or perhaps purchase of your equipment if you are getting out....thanks!

Report message to a moderator

Re: Bullet casting [message #3523 is a reply to message #3520] Fri, 18 February 2011 08:50 Go to previous message
Tom in Arizona is currently offline  Tom in Arizona
Messages: 18
Registered: December 2010
Location: Munds Park, AZ
Forum Newbie
It all depends upon how much you can afford,the value you place on your time and how much space you can dedicate to bullet casting to even begin discussing the "best" equipment for an individual to cast the bullets they want to use.

Take a look here for a wealth of information: http://castboolits.gunloads.com/

Tom

Report message to a moderator

Previous Topic: Duracoating question
Next Topic: Front sight installation
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ]

Current Time: Mon Apr 29 07:54:34 EDT 2024
.:: Contact :: Home ::.