Thompson Center Encore Classifieds
Find your Encore Barrels here!

Home » General Conversation » DIY Gunsmithing » Front sight screw size...??
Front sight screw size...?? [message #661] Wed, 25 November 2009 19:16 Go to next message
JGant
Messages: 16
Registered: November 2009
Location: SE Mi
Forum Newbie
Hi,
I planning on getting a Encore pistol 15" blue .243 barrel.
I would like to remove the front sight and "fill" the hole(s) with the proper size screws.
Does anyone know the size, length, & thread to replace the original sight screw(s).
Obviously, I would like them flush with the top of the barrel.
Thanks,
John

[Updated on: Wed, 25 November 2009 19:16]

Report message to a moderator

Re: Front sight screw size...?? [message #664 is a reply to message #661] Thu, 26 November 2009 22:19 Go to previous messageGo to next message
littleking is currently offline  littleking
Messages: 531
Registered: January 2008
Location: Columbus, OH
Senior Member
Forum Admin

i've been looking for them too

[Updated on: Thu, 26 November 2009 22:19]

Report message to a moderator

Re: Front sight screw size...?? [message #669 is a reply to message #664] Fri, 27 November 2009 09:20 Go to previous message
JGant
Messages: 16
Registered: November 2009
Location: SE Mi
Forum Newbie
If I find out what they are....I'll post it....I'm due to pick up the barrel around mid week, next week....maybe the shop will have that info..
TC customer service is right at the bottom of my list as far as service.
Take Care...

Found them at Gander Mtn gunsmith...
They are 6-48 x .090 .....

[Updated on: Fri, 27 November 2009 18:16]

Report message to a moderator

Previous Topic: T/C Encore small parts
Next Topic: Refinished Stock/Forearm
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ]

Current Time: Mon Apr 29 07:19:39 EDT 2024
.:: Contact :: Home ::.