Thompson Center Encore Classifieds: Reloading

Home » General Conversation » Reloading » 35 Remington (Anyone making 35 Rem brass from other calibers?)

Show: Today's Messages :: Polls :: Message Navigator
E-mail to friend

35 Remington [message #40246]

Tue, 26 January 2016 10:16

guncrazyhoosier
Messages: 19
Registered: December 2015
Location: NE Indiana

Forum Newbie

I am making 35 Remington brass from 308. The process is a bit laborious but the resulting cases are strong due to case wall thickening during the process, with the additional downside of a reduced case capacity compared to the 35 Rem. Due to decreased case capacity chamber pressures can climb if not careful to reduce powder charges from 35 Rem loads, but I found these cases and loads perform well against 35 Rem brass and loads.

Anyone else also making 35 Rem from 308 or other brass? What ae your experiences?

Report message to a moderator

[Message index]

		35 Remington By: guncrazyhoosier on Tue, 26 January 2016 10:16
		Re: 35 Remington By: rchatting on Tue, 26 January 2016 13:53
		Re: 35 Remington By: gemihur on Tue, 26 January 2016 17:09
		Re: 35 Remington By: guncrazyhoosier on Tue, 26 January 2016 21:45
		Re: 35 Remington By: guncrazyhoosier on Tue, 26 January 2016 22:18
		Re: 35 Remington By: rchatting on Fri, 29 January 2016 13:02
		Re: 35 Remington By: bstewrat3 on Sun, 11 December 2016 11:14
		Re: 35 Remington By: sunnysmarine on Mon, 23 October 2017 11:40

Previous Topic:	reduced recoil loading
Next Topic:	PSA - Stainless pin tumblers - Do not tumble .44 and .357/ .38 together

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

]

Current Time: Sat May 18 04:28:07 EDT 2024