Thompson Center Encore Classifieds
Find your Encore Barrels here!

Home » General Conversation » Gun Talk » 16 1/4" Encore Factory Barrels
Re: 16 1/4" Encore Factory Barrels [message #33263 is a reply to message #33261] Tue, 23 September 2014 23:25 Go to previous messageGo to previous message
jamesgammel is currently offline  jamesgammel
Messages: 1708
Registered: August 2012
Location: Lovell, Wyoming
Top Contributor
upper right corner will usually be the packer's initials. If a Custom Shop job, you'll also see a "cs" in that corner too. Most times you'll see the C/S logo on the right side of the barrel. If it's a TCA barrel, you'll usually see "TCA" near the front end of the hinge lug on the left side of the barrel.
Jim

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Federal .22 UltraMatch?
Next Topic: Encore bullet tumble
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ]

Current Time: Fri May 17 07:11:21 EDT 2024
.:: Contact :: Home ::.