Thompson Center Encore Classifieds: DIY Gunsmithing

Home » General Conversation » DIY Gunsmithing » Encore Trigger (Has anyone tried this)

Show: Today's Messages :: Polls :: Message Navigator
E-mail to friend

Encore Trigger [message #35922]

Thu, 22 January 2015 00:03

pinecone
Messages: 116
Registered: May 2014
Location: Northwest

Junior Member

I found an article on the internet (where else!!) that showed and explained how to weaken the trigger spring in an Encore and thus making the trigger pull lighter. The explanation was to push down on the spring therefore weakening it. this would then lighten the trigger pull. The narrator also said going to a heavier hammer spring instead of the factory spring would also lighten trigger pull. Has anyone done this and did it work ? Thanks for your imput.

Report message to a moderator

[Message index]

		Encore Trigger By: pinecone on Thu, 22 January 2015 00:03
		Re: Encore Trigger By: jplucas6.5 on Thu, 22 January 2015 08:37
		Re: Encore Trigger By: sunnysmarine on Thu, 22 January 2015 11:01
		Re: Encore Trigger By: rchatting on Thu, 22 January 2015 13:07
		Re: Encore Trigger By: pinecone on Thu, 22 January 2015 18:34
		Re: Encore Trigger By: cajuntec on Thu, 22 January 2015 18:56
		Re: Encore Trigger By: pinecone on Wed, 11 February 2015 01:54
		Re: Encore Trigger By: kc2htv on Wed, 11 February 2015 07:55
		Re: Encore Trigger By: WV338 on Sun, 05 April 2015 14:55
		Re: Encore Trigger By: jamesgammel on Sun, 05 April 2015 19:47

Previous Topic:	Katahdin Rear sight
Next Topic:	Adjusting ejector

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

]

Current Time: Fri May 17 00:21:23 EDT 2024