Thompson Center Encore Classifieds: DIY Gunsmithing

Home » General Conversation » DIY Gunsmithing » Adding pillars to forend

Show: Today's Messages :: Polls :: Message Navigator
E-mail to friend

Adding pillars to forend [message #37984]

Mon, 30 March 2015 11:52

SuperKirby
Messages: 75
Registered: February 2011
Location: MN

Novice Contributor

I have a muzzleloader barrel from MGM and a laminate forend from Boyds. I like them both. Unfortunately if I tighten the forend down, I can't get the ramrod out. If I leave the forend loose enough to get the rod out, there's play in the forend. I'm thinking I should try to add pillars to forend to get the right spacing and still be able to pull the rod out. I've never done anything like this but it doesn't seem like it should be too hard. Can anyone tell me where to start, what to use, and how to do it?

Thanks.
Vince

Report message to a moderator

[Message index]

		Adding pillars to forend By: SuperKirby on Mon, 30 March 2015 11:52
		Re: Adding pillars to forend By: Doyle on Mon, 30 March 2015 13:16
		Re: Adding pillars to forend By: jamesgammel on Mon, 30 March 2015 17:52
		Re: Adding pillars to forend By: SuperKirby on Tue, 31 March 2015 01:35
		Re: Adding pillars to forend By: rchatting on Tue, 31 March 2015 06:44
		Re: Adding pillars to forend By: SuperKirby on Wed, 01 April 2015 01:33
		Re: Adding pillars to forend By: rchatting on Wed, 01 April 2015 06:42

Previous Topic:	Size of rear sight blade screws?
Next Topic:	Contender Barrel Forearm Dovetail Cut

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

]

Current Time: Thu May 02 20:56:48 EDT 2024