| Knife and chisel sharpening [message #38626] |
Sat, 20 June 2015 17:45  |
|
|
I have a 1" X 30" belt sander and am wanting to use it to sharpen knives and also wood lathe chisels. My question is what grit and type of belts should I get for this job? I am planning to start small and then perhaps get a leather strop for the setup later. 400, 600, 800, or 1000 grit? I know enough to not hoss a blade into the belt and get it hot. Was going to practice on some older cheap blades first. Any advice would be helpful. Thanks
Murl
Mr. Murl
ΜΟΛΩΝ ΛΑΒΕ
Molan Labe
"They that can give up essential liberty to obtain a little temporary safety deserve neither safety nor liberty." - Benjamin Franklin
“Quemadmoeum gladuis neminem occidit, occidentis telum est.” (A sword is never a killer, it is a tool in the killer’s hands.) – Lucius Annaeus Seneca, circa 4 BC – 65 AD
"America will never be destroyed from the outside.
If we falter and lose our freedom, it will be because
we destroyed ourselves."
~ ~ Abraham Lincoln ~ ~
|
|
|
|
] 
Thompson Center Encore Classifieds
Search
Help
Members
Register
Login
Home
