| Re: Encore Assembly [message #39163 is a reply to message #39073] |
Wed, 16 September 2015 15:02   |
 |
Crubear
Messages: 1798
Registered: March 2010
Location: NW Georgia
|
Top Contributor
Forum Moderator |
|
|
So, carrying on....
Lay the frame on it's right side, you can see why by looking at the interlock in relation to the trigger guard.
Put the sear into the hole in the interlock, and slide that into the frame.
-- The long end of the sear goes up and the short end points to the rear.
-- The spring in the interlock presses against the hammer post, so you'll have to kind of slide it around the post, then slide the interlock up against the frame.
Now, comes the fun. Take your punch and try to get it to feed through the holes for the sear pin. If you want, you can use the pin as well. Either works fine. This takes a bit of finesse, since you have to line up the holes. So be patient, don't force it, and take your time.
Once you have the pieces pinned in place, use the tip above and insert the punch/pin to create a gap to put the spring in.
Honestly, I have all the barrels I want or could ever need..... wait, look, there's another!!
[Updated on: Wed, 16 September 2015 15:05] Report message to a moderator |
|
|
|
] 
Thompson Center Encore Classifieds
Search
Help
Members
Register
Login
Home
