Re: Encore Assembly [message #39169 is a reply to message #39168] |
Wed, 16 September 2015 15:49 |
|
Crubear
Messages: 1798 Registered: March 2010 Location: NW Georgia
|
Top Contributor Forum Moderator |
|
|
Now, screw the screw in. Check for extra parts, because if there are any you didn't do it right
Then, slide your finger into the frame (you're simulating a barrel and locking bolts) and push the interlock back and pull the hammer back until it locks in place.
Now, if the hammer doesn't have any tension on it all all - your forgot the hammer spring.
If it doesn't lock back with tension, then you probably forgot the sear spring
If it won't go back at all, then you have the sear spring inside the sear.
Pull the trigger and you should get a solid hammer drop and click. Please note though, if there's no barrel it probably won't hit where the firing pin is. The interlock will keep the hammer from reaching the frame. So don't be alarmed if you see a gap after pulling the trigger
Honestly, I have all the barrels I want or could ever need..... wait, look, there's another!!
|
|
|