| Anybody add sights to an Encore Barrel? [message #5560] |
Thu, 28 July 2011 12:07  |
Quarterbore
Messages: 5
Registered: March 2011
Location: Valley Forge PA
|
Forum Newbie |
|
|
I am sure a good gunsmith can do this but looking for general advise and to see if anybody has had it done. I have a 26-inch Medium profile 308 barrel that I want to get cut down to make a smaller pack rifle and in the process I want to add a set of iron sights to the barrel.
I am planning to get the barrel cut down to about 18-inches and the real purpose of the rifle will be for hunting where I hike in long distances. I would take the rifle into the woods in my pack and assemble it once I get to my hunting spot. I may also look at some system were I could use a scope or the irons when I do this but obviously that makes this far more complicated.
|
|
|
|
] 
Thompson Center Encore Classifieds
Search
Help
Members
Register
Login
Home
