Thompson Center Encore Classifieds
Find your Encore Barrels here!

Home » General Conversation » DIY Gunsmithing » Muzzleloading barrel on "G1" frame
Muzzleloading barrel on "G1" frame [message #42758] Sat, 18 March 2017 16:23 Go to previous message
rootmanslim is currently offline  rootmanslim
Messages: 11
Registered: November 2016
Forum Newbie
Thompson was sneaky by putting a pin on the bottom of the MZ bbls lug to preclude using in a G1 frame. Not so fast !

Okay ! Got her wrapped up ! Got a G1 stock from Boyds (cheaper than factory) Cut that pin off and she closed right up and worked fine. Relieved the forend wood so it did not hit TG. Barrel came with mounts and I had a nice Nikon shotgun scope to drop on it. So if all you have are "G1" frames and are lucky enough to score a MZ bbl, it can be done.
  • Attachment: DSCN5208.jpg
    (Size: 379.59KB, Downloaded 374 times)
  • Attachment: DSCN5207.jpg
    (Size: 407.97KB, Downloaded 371 times)
  • Attachment: DSCN5210.jpg
    (Size: 782.06KB, Downloaded 341 times)

[Updated on: Sat, 18 March 2017 23:43] by Moderator

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Encore Pistol sling swivel bolt
Next Topic: Cutting a synthetic stock???
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ]

Current Time: Sat May 18 00:37:30 EDT 2024
.:: Contact :: Home ::.