Thompson Center Encore Classifieds: DIY Gunsmithing

Home » General Conversation » DIY Gunsmithing » Encore scope base (Will not stay zeroed )

Show: Today's Messages :: Polls :: Message Navigator
E-mail to friend

Re: Encore scope base [message #43587 is a reply to message #43586]

Thu, 23 November 2017 19:40

sunnysmarine
Messages: 987
Registered: July 2011
Location: CA

Senior Member

when the group moves do all rounds then group at the new point of impact, or do you readjust to compensate before shooting again? in a bolt gun I have had the same sort of problem occurred a business card under the barrel ended the problem doubt that would help here, everything else remains the same? ammo different boxes different lots? I think if it was the base it would not group at all with that much movement

Report message to a moderator

[Message index]

		Encore scope base By: Rjason on Thu, 23 November 2017 19:04
		Re: Encore scope base By: sunnysmarine on Thu, 23 November 2017 19:40
		Re: Encore scope base By: Rjason on Thu, 23 November 2017 19:57
		Re: Encore scope base By: rchatting on Wed, 13 December 2017 21:29
		Re: Encore scope base By: kilibreaux on Mon, 18 December 2017 02:14
		Re: Encore scope base By: Shooting50 on Thu, 06 September 2018 21:50
		Re: Encore scope base By: Crubear on Mon, 10 September 2018 10:00

Previous Topic:	New furniture
Next Topic:	Extractor spring Question

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

]

Current Time: Thu May 16 07:29:52 EDT 2024