Thompson Center Encore Classifieds: DIY Gunsmithing

Home » General Conversation » DIY Gunsmithing » Encore problem (257 Roberts)

Show: Today's Messages :: Polls :: Message Navigator
E-mail to friend

Encore problem [message #15999]

Wed, 14 November 2012 18:48

buster
Messages: 20
Registered: May 2012
Location: WV

Forum Newbie

I recently purchased a 15in. 257Robert barrel,from another site, it was a new MGM barrel unfired. While shooting barrel had problems opening after firing, finally got open and it appears to be blowing primers out of casing. This was with Federal and Remington factory ammo,also lucky to hit paper with it.Looking for any ideas for this problem or cure. Thanks, Buster

Report message to a moderator

[Message index]

		Encore problem By: buster on Wed, 14 November 2012 18:48
		Re: Encore problem By: Doyle on Wed, 14 November 2012 21:29
		Re: Encore problem By: Crubear on Wed, 14 November 2012 21:53
		Re: Encore problem By: jamesgammel on Thu, 15 November 2012 10:16
		Re: Encore problem By: Doyle on Thu, 15 November 2012 13:52
		Re: Encore problem By: Crubear on Thu, 15 November 2012 16:14
		Re: Encore problem By: kc2htv on Thu, 15 November 2012 19:56
		Re: Encore problem By: Crubear on Fri, 16 November 2012 08:04
		Re: Encore problem By: jamesgammel on Fri, 16 November 2012 12:13

Previous Topic:	Needed Encore Parts
Next Topic:	Rear sight height question

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

]

Current Time: Sun May 12 17:56:03 EDT 2024